Epson Stylus Pro 7500 - User Paper Setting Menu

EPSON Stylus Pro 7500 Revision A
Product Description Panel Setting Menu 44
1.6.4 User Paper Setting Menu
It is possible to set the values of the following setting items in the user paper setting menu.
However, in this item, if “Standard” is selected, the following “Paper Thickness Sensing
Pattern” and “Paper Thickness No.” are not displayed. Each setting is accomplished by
operating the following panel buttons.
o User Paper Setting Menu Selection: See the Panel Setting Menu
procedure.
o User Paper Setting Item Selection: “Paper Source” Button
o Changing the Setting Value: “+” or “–” Button
o Setting the Set Value: “Enter” button
Mode End: “Pause” Button
by running this mode, the user can have the printer sense the thickness of the paper he or
she has selected and can register up to 4 types of paper as user defined paper. The ink
drying time and the suction force during suction can also be registered for each paper. the
setting method is shown below.
1) Enter the User Paper Setting Menu by the panel.
2) Select a paper type. When “Standard” is selected, proceed to (5), and when “1” ~
“4” is selected, proceed to 3).
3) Print the paper thickness sensing patterns. (See the figure below.)
4) Look at the patterns and select the number of the pattern which has the least
deviation.
5) Input the ink drying time.
6) Select the suction force (Standard / Weak).
Figure 1-10. Paper Thickness Sensing Patterns
The No where the gap between
the top and bottom pattern is
“0” should be selected.