Epson Stylus Pro 7500 - Conversion Kit Parts Replacement Procedure

EPSON Stylus Pro 7500 Revision A
Disassembly & Assembly Disassembly Flow 148
9. When the transport liquid discharge sequence is completed, the message “Adj: Counter
Clear” will be displayed in the LCD. When the Enter button is pressed, the message
“Reset Counters ?” will be displayed in the LCD. By pressing the Enter button, the
counters for the above items will be reset. By executing this operation, initial filling
will be done automatically when the power is turned ON next.
n Ink cartridge consumption counter
n Waste ink counter
n Initial ink filling flag set
10. Turn the printer’s power OFF, then pull the AC plug out of the AC outlet.
CONVERSION KIT PARTS REPLACEMENT PROCEDURE
1. Release the 2 hooks fitting into the left and right sides of the control panel and remove
the control panel.
Figure 4-94. Removing the Control Panel
2. Pull out the FFC that is run from the top of the control panel to the panel board.
Figure 4-95. Disconnecting the Control FFC
Control Panel
Control Panel FFC Connector
Control Panel Back