Epson Stylus Pro 7500 - Panel Display

EPSON Stylus Pro 7500 Revision A
Product Description Panel Display 36
1.5 Panel Display
Messages corresponding to the printer status, error occurrence and other states are
displayed in the operation panel LCD. The messages displayed are shown in the following
table. Furthermore, the messages are shown in their display processing priority order, from
the highest priority messages to the lowest.
*1:If “Widen” is selected in the “Platen Gap” item in the panel settings, a “H” is displayed in the
20th column.
*2:See Chapter 3, “Troubleshooting”
*3:See Chapter 3, “Troubleshooting”
*4:“Initial filling in progress” displays the processing progress conditions. Initial filling ends at
the point when this value becomes 100%.
Table 1-21. List of Panel Display Messages
Display Content
SERVICE REQ nnnnnnnn *2 Fatal error occurrence state.
MAINTENANCE REQ nnnn *3
Indicates an error occurrence state that requires
maintenance by a service man (such as the end of the
waste ink pad’s service life).
WAIT *1
Resetting the timer IC.
Clearing NVRAM.
Resetting.
Executing the ink sequence.
Executing initialization processing.
Processing paper initialization.
POWER OFF Executing power off processing.
INK OUT Ink out.
COVER OPEN Cover open state.
OPTION I/F ERROR A Type B interface error occurred.
TRANSPORT PREP
Executing ink discharge sequence for transport
between users.
SECURE PAPER LEVER The paper support lever was released during operation.
LOAD xxx PAPER
The roll paper and cut sheet paper settings are
different.
PAPER JAM A paper jam occurred.
PAPER NOT CUT A paper cutting error with the auto cut settings.
PAPER NOT STRAIGHT Paper is being fed at a slant.
LOAD PAPER The paper support lever is released.
RELOAD PAPER
Paper Eject failed. (in the case of cut sheets)
Paper recognition error.
REMOVE PAPER Impossible to carry out cleaning.
NO INK CARTRIDGE The ink cartridge is not set.
PRESS PAUSE BUTTON
Waiting for the paper initialization processing start
trigger.
PAUSE Pause state (standby)
INK DRY xx MIN Ink is drying (“xx min.” = time remaining)
INK LOW
Remaining ink is low. (replacement preparations are
necessary)
INK CHARGING nnn% Initial filling in progress *4
PRINTING *1 Processing data (printing operation in progress)
READY *1 Printer is ready to receive data
PAPER OUT
Paper not set state
End of roll paper.
RESET Reset processing in progress
TURN PWR OFF AND ON
Instruction to turn the power on again. (Turn it off,
then turn it on again.)
Table 1-21. List of Panel Display Messages
Display Content