Epson Stylus Pro 7500 - Self-diagnostic Function

EPSON Stylus Pro 7500 Revision A
Adjustment Adjustment Steps 179
5.2.3 Self-diagnostic Function
The function built into this printer which performs each type of printer adjustment is called
the “Self-diagnostic Function” mode. If you are performing any of the adjustments, start
this mode by the following method, select the necessary adjustment item from the menu,
and execute it.
5.2.3.1 Starting the “Self-diagnostic Function”
1. Switch the printer’s power On while pressing the following buttons on the operation
panel.
[Paper Feed +] + [Paper Feed –] + [Enter]
2. “Check: Test” and the menu items are displayed in the LCD panel in the operation
panel and the self-diagnostic function mode starts.
In the Self-diagnostic Mode, the functions of each button on the operation panel are
changed as shown in the table below.
3. Switch the printer’s power off to finish the self-diagnostic Function.
Figure 5-1. Self-diagnostic Function - Panel Functions
Table 5-3. Self-diagnostic Function Mode - Panel Operation
Normal Mode Self-diagnostic Mode Functions
Pause Previous Level
Returns the setting item to the previous level of the
menu hierarchy.
SelecType Setting Item (Next) Displays the next menu.
Paper Source
Setting Item
(Previous)
Displays the previous menu.
+ (Paper Feed ↑) Setting Value + Changes the setting value on the plus side.
– (Paper Feed ↓) Setting Value – Changes the setting value on the minus side.
Cut / Eject (Enter) Enter Sets the setting value.
Cleaning Paper Feed & Cut
If it is pressed, the paper is fed, and when it is
released, the paper is cut.
CAUTION
n Except as otherwise specified, EPSON MC Thick Mat Roll Paper
(MCSP24R4) should be used for test printing.