EPSON Stylus Pro 7500 Revision A
Disassembly & Assembly Disassembly Flow 161
51. Put the front end of the ink supply tube in the damper’s connection fitting, then tighten
the hex nut with the exclusive torque wrench. If excessive tightening torque is used, it
will cause the O-ring to be deformed, resulting in ink leaking and air bubbles getting
mixed into the ink.
Figure 4-132. Tightening the Hex Nuts
52. Assemble the damper holder and CR cover.
53. Install the right side cover.
AFFIXING LABELS
1. Affix the following labels in the specified locations.
n
EPSON COLOR FAST Label
Affix this label on the bottom of the right side cover panel. (In the EPSON
COLOR Fast label position)
n
Manual Cutter Cutting Position Labels
Vertical Position: Align the scissors cutting line on the label with a position 12.7
cm down from the bottom of the paper guide L sub-platen.
Horizontal Position: Align the label’s left edge with a position 3 cm from the right
side frame edge.
Figure 4-133. Label Affixing Position
CHECK
PO INT
When you are connecting the ink supply tubes to the dampers using
the hex nuts, the exclusive tool #F760 should be used.
EPSON COLOR FAST
12.7 cm
(down from the bottom of the
paper guide L sub-platen to the
scissors cutting line position)
3cm
To Next Page
Loading...
