Epson Stylus Pro 7500 - Ink Cartridge Size Select; Inter-User Transport Mode

EPSON Stylus Pro 7500 Revision A
Product Description Ink Cartridge Size Select 53
1.7 Ink Cartridge Size Select
The size the ink cartridges installed in this printer are selected manually. Automatic
detection of their size is not performed. It is necessary that the ink cartridge size decided
here match the size of the actual ink cartridge, and further, it is necessary that all the ink
cartridges installed in the printer be the same size. Also, calculation and display of the
remaining ink volume is based on the values set here.
o Starting Method:
The ink cartridge size selection mode starts if the power switch is pressed while
the following panel button is being pressed.
n SelecType Button
o Operation Method:
(1) Each time the [Setting Value + Button] or the [Setting Value – Button] is
pressed, the settable ink cartridge size value is changed in sequence in the display
with the format “Ink Cartridge Size” = [Setting Value] (*). The “*” on the end is
the setting value and is displayed only when the value displayed is the current
setting value. Also, pressing the [Setting Value – Button] causes the settable
values to be displayed in reverse sequence.
(2) If the Enter button is pressed, the displayed setting value is set and registered
as the current setting value.
o Ending Method
(1) Turn the power OFF, then ON again.
(2) Reset the printer after setting. It will automatically change to the Pause state.
o Ink Cartridge Size Setting Menu:
1.8 Inter-User Transport Mode
This is a mode to discharge the ink that the printer is filled with and make it possible to
transport the printer. It is necessary for the user to perform the following operations before
transporting the printer and make it possible for the printer to be transported.
(1) At a time when the printer’s power is turned on,. the ink cartridges of each color
should be removed.
(2) Turn the printer’s power off.
(At this time, the printer will execute the ink discharge sequence for transport
automatically. The message “TRANSPORT PREP n n %” will be displayed, and the [n
n %] will indicate the progress condition.)
*1: The paper support lever should be in the returned position and the power should be
turned Off. (When the paper support lever is in the backward state, even if the power is
turned Off, the sequence of discharging the ink for transport is not performed.)
*2: If the “Inter-user Transport Mode” ends without any trouble, the “Initial Filling” flag is
set (the same state as when the printer was shipped from the factory). When the printer is
refilled with ink, the same operation as the initial filling operation should be carried out.
Table 1-43. Ink Cartridge Size Setting Menu Item
Item Panel Display Setting Value
Ink Cartridge Size Selection
Ink Cartridge Size
Setting
100ml
200ml