Epson Stylus Pro 7500 - Printer Setting Menus

EPSON Stylus Pro 7500 Revision A
Product Description Panel Setting Menu 38
1.6.1 Printer Setting Menus
In the printer setting menus, it is possible to change the set values in the setting items in the
following table. Each setting is made by operation of the following panel buttons.
o Printer setting menu selection: See the panel setting menu procedure.
o Printer setting item selection: “Paper Source” button
o Change the set value: “+” or “–” button
o Set the settings: “Enter” button
o Mode End: “Pause” button
A list of setting items in the printer setting menu is shown below.
Table 1-23. List of Setting Items in the Printer Setting Menu
Display Setting Value Contents
PLATEN GAP
AUTO *1
WIDE
Adjusts the platen gap. (Ordinarily, this is done
automatically.)
PAGE LINE
ON*2
OFF
While in the “Roll Paper Cutter Off” selection
state, this sets whether or not to print a cutting
line (solid line) at the bottom edge of the sheet
when the roll paper is ejected.
INTERFACE
AUTO *3
PARA./USB
OPTION
Interface receiving setting (Auto select or fixed
on a single interface)
PARA. I/F
COMPAT
ECP
Sets the parallel interface receiving rate.
(Ordinarily, it is used with the “Compatible”
setting.)
CODE PAGE
RC437*5
PC850
Character code set selection.
(PC437: Expanded graphics / PC850: multi-
lingual.
ROLL MAGE
T/B 15MM *6
3MM
15MM
Sets the margin on roll paper *2
Vertical 15 mm: Leaves 15 mm on the left and
right edges of the printable area, and a 3 mm
margin at the top and bottom. / Leaves a 3 mm
margin at the top, bottom, left and right. / 15
mm: Leaves a 15 mm margin at the top, bottom,
left and right.
PAPER SIZE CHK
ON*7
OFF
Perform / Don’t perform automatic sensing of
the paper width.
PAPER ALIGN CHK
ON*8
OFF
Perform / Don’t perform automatic sensing of a
paper skew error.
INIT. PANEL EXEC.
Returns the panel setting contents to their initial
values.
Table 1-23. List of Setting Items in the Printer Setting Menu
Display Setting Value Contents