Epson Stylus Pro 7500 - Updating Firmware from a Memory Card

EPSON Stylus Pro 7500 Revision A
Adjustment Adjustment Steps 178
UPDATING FIRMWARE FROM A MEMORY CARD
1. Make sure “Ready” appears on the LCD. Press the SelecType button multiple times
until “Printer Status Menu” appears. Then press the Item button.
“Version LO xxxxx” appears. Write down the version number.
2. Turn off the printer.
3. Remove the access cover from the rear of the printer, and insert the prepared firmware
card (xxxxxxxx.ROM) into slot CN20. The top surface of the card faces the outside of
the printer.
The card is EPSON service tool #F727 Flash memory card.
NOTE: The memory card should be inserted so that its top is toward the printer’s
outside.
4. Turn on the printer.
5. "Update Complete" appears when the firmware update has finished.
6. Turn off the printer, remove the memory card, and then turn on the printer.
7. Verify the firmware version according to the directions in step 1, turn off the printer,
and see the Caution at the top of the previous page.
CAUTION
n In either method, if update processing stops midway, (if the
power goes off, etc.), it can be recovered from by repeating this
operation.
n The memory card which the firmware data are written on should
be the exclusive “Sylus Pro 7500 Firmware Reload” card.