EPSON Stylus Pro 7500 Revision A
Adjustment Adjustment Steps 204
5. After confirming that “GAP completed.” is displayed in the LCD, execute the final
check item.
FLUSH POINT ADJUSTMENT
This function corrects the flushing position of the carriage to make sure the carriage is
properly positioned over the F Box during the flushing operation.
1. Make sure "Adj. Flush Point R" appears in the LCD, and press the Enter button.
2. The carriage moves to the flushing position and begins flushing.
3. After flushing is finished, "Point R NNN" (NNN = numeric position) appears.
Check the piece of paper you put over the flushing box to confirm the ink is ejected
into the flushing box. If the ink-flushing position is correct, press the Enter button to
finish. Otherwise, press the SelecType or Item button to correct the flushing position.
The settings increment as follows.
Correction distance: One press = 1/720 inch
Direction: "+" = toward HP and "-" = away from HP
Figure 5-32. Flushing Point Check Operation
CAUTION
n Since you do not have the L flushing box, the “Flushing Point L
Adjustment” should not be performed. If it is performed,
“Service Call 0003000D” will be generated.
To Next Page
Loading...
