Epson Stylus Pro 7500 - Page 144

EPSON Stylus Pro 7500 Revision A
Disassembly & Assembly Disassembly Flow 144
4.2.3.16 Removing the Cover Sensor Assembly
1. Perform the Steps 1 to 13 in “I/C Holder Cover Removal” on page 105.
2. Separate the harnesses for the Cover Sensor Assembly from the six harness connectors
for the Ink Cartridge Sensor and harness bundle for the Cover Sensor Assembly.
3. Remove the two (CP(W) M2x12) screws securing the Cover Sensor Assembly and
Cover SW Holder, and remove the Cover Sensor Assembly.
Figure 4-93. Removing the Cover Sensor Assembly
ADJUSTM ENT
REQUIRED
Perform the necessary adjustment listed in Table 5-2 in Chapter 5 on
Page172. This adjustment is required to make the Cover Sensor
Assembly work interlocking with the close/open status of the Front
Cover.
cover sensor assembly
screws(M2x12)
cover switch
holder