Epson Stylus Pro 7500 - Page 173

EPSON Stylus Pro 7500 Revision A
Adjustment Adjustment Outline 173
<Sensor Replacement 5>
CR Encoder Sensor
Assembly
<CR encoder sensor installation position
adjustment>
1. Required tool: CR ENC sensor installation tool
#F757
224
<Sensor Replacement 6>
Cover Sensor Assembly
<Start the self-diagnostic function>
1. Inspect “Covers” under the “Sensors” item in this
menu.
223
<Sensor Replacement 7>
PF Encoder Sensor
Assembly
1. <Adjust the PF ENC installation position>
Required tool: PF ENC Installation Position
Adjustment tool #F764
<Adjust the PF ENC installation position 2>
Required tool: PF ENC Installation Position
Adjustment tool 2 #F765
230
CR Encoder Scale
Fastening Plate Removal
1. <Adjust the CR encoder scale installation
position.>
Required tool: CR ENC Scale Installation Position
Adjustment tool #F758
225
CR Solenoid Assembly
Replacement
or
Paper Guide L Removal
1. <Adjust the cutter’s positioning>
Required tool: Cutter Positioning tool #F763
<Check the paper cutting position>
226
Table 5-2. Service Parts & Required Adjustments (continued)
Service
Operation
Adjustment Items Refer to page