Epson Stylus Pro 7500 - Page 198

EPSON Stylus Pro 7500 Revision A
Adjustment Adjustment Steps 198
follows depending on the degree of inclination. (The check pattern color will differ
during C head adjustment. After the adjustment, return the carriage to the cap position
and close the front cover.
4. Using the [SelecType] / [Paper Source] buttons, select the “Pattern Output” display,
then print the check pattern once more and check the degree of inclination. If there is
no problem, press the Enter button when “Inclination Check End” is displayed, and the
operation will end.
Figure 5-20. Head Slant Check Operation
Figure 5-21. B/C Head Slant Adjust Lever
B head
C head
B head
C head
head adjustment A