Epson STYLUS PRO 9400 - Page 256

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 256
6. Disconnect the connector of the PF MOTOR ASSY. from the relay connector, and
release the PF MOTOR ASSY. harness from the retaining clip. See Figure 4-85.
7. Remove the four screws that secure the PF Motor Mounting Plate. See Figure
4-85.
 Four C.P.S.(S-P2) M4 x 8 screws
8. Release the hooked tab of the PF Motor Mounting Plate, remove the X
REDUCTION BELT from the pinion gear of the PF MOTOR ASSY., and then
remove the PF Motor Mounting Plate together with the PF MOTOR ASSY. See
Figure 4-86.
Figure 4-85. Screws Securing the PF Motor Mounting Plate
Figure 4-86. Removing the PF Motor Mounting Plate
 Set the two positioning holes of the PF Encoder Mounting Plate
onto the two guide pins. See Figure 4-83.
 After installing the PF Encoder Mounting Plate, make sure that
the SCALE, PF is properly inserted into the slit of the PF
Encoder Sensor.
Figure 4-84. Reinstalling the PF Encoder Mounting Plate
 Before screwing the SCALE, PF, adjust its position to the
center of the slit so that the scale does not contact with the
sensor.
SCALE, PF
PF Encoder Sensor
C.P.S.(S-P2) 4x8
Relay Connector
Retaining Clip
PF Motor Mounting Plate
Hooked tab
X REDUCTION BELT
8
Pinion Gear