❏ Manual cut:
Press the ) button to cut the paper using the
built-in cutter. A cutline is printed for manual
cutting and can be used as a guide when cutting
paper using the built-in cutter.
You can specify the method either from the control
panel or the printer driver. Note, however, that the
setting selected with the printer driver takes priority
when the printer driver is used.
Note:
❏ Disable printer driver Auto Cut and printer Auto
Cut options when using the optional auto take-up
reel unit.
❏ It may take a while to cut the roll paper.
❏ Some of the roll paper may not be cut using the
built-in cutter. Use a cutter sold at a store to cut the
paper.
Follow the steps below when using a third-party
cutter.
Press the ) button. Keep the d button pressed to
feed the paper so that the cut location is below the
paper eject guide. Cut the paper using scissors or a
third-party cutter.
Setting methods
Setting on the computer
Set Auto Cut from the Advanced tab - Roll Paper
Option in the printer driver’s Properties (or Printing
preferences) screen.
Setting from the printer
Use the l/r buttons in the control panel to select the /
tab and press the Z or Menu button. The Setup menu
will be displayed; select Printer Setup > Roll Paper
Setup> Auto Cut > On and press the Z button. For
manual cutting, select Off. The default setting is On.
U “Setup menu” on page 107
Manual cut method
When Off is selected in the printer driver or Off is
selected for Auto Cut in the control panel, the paper can
be cut in any location after printing as described below.
Buttons that are used in the following settings
Cutting paper manually using the built-in cutter
A
Press the ) button. Viewing the interior of the
printer without opening the printer cover, press
the d button to align the cut location with the
mark on the right side of the printer’s
interior.
Note:
The minimum length of paper that can be cut with
the built-in cutter is fixed at 60 to 127 mm and
cannot be changed. If the cutting position is shorter
than the shortest length above, the paper has to be
automatically fed to that length thus a margin will
have to be left. Cut off the margin with a cutter sold
at a store.
B
Press the Z button.
The paper is cut by the built-in cutter.
SC-T7000 Series/SC-T5000 Series/SC-T3000 Series User's Guide
Basic Operations
27
To Next Page
Loading...
Need help?
General
