Epson SureColor SC-T3000 User Manual

Replacing Consumables
Replacing Ink Cartridges
If one of the installed ink cartridges is expended,
printing cannot be performed. If an ink low warning is
displayed, we recommend replacing the ink cartridge(s)
as soon as possible.
If an ink cartridge runs out while printing, you can
continue printing after replacing the ink cartridge.
However, when replacing ink during a print job, you
may see a difference in color depending on the drying
conditions.
Supported ink cartridges U “Options and
Consumable Products” on page 137
How to replace
You can use the same procedure to replace all ink
cartridges.
c
Important:
Epson recommends the use of genuine Epson ink
cartridges. Epson cannot guarantee the quality or
reliability of non-genuine ink. The use of
non-genuine ink may cause damage that is not
covered by Epson’s warranties, and under certain
circumstances, may cause erratic printer behavior.
Information about non-genuine ink levels may not
be displayed, and use of non-genuine ink is recorded
for possible use in service support.
A
Make sure the printer is on.
B
Open the cartridge cover.
C
Hook a finger into the indentation on top of the
ink cartridge and pull it straight out.
c
Important:
Removed ink cartridges may have ink around
the ink supply port, so be careful not to get any
ink on the surrounding area when removing
the cartridges.
D
Remove the new ink cartridge from the bag.
Shake the ink cartridge for 10 seconds 30 times
horizontally in approximately 5 cm movements
as shown in the illustration.
c
Important:
Do not touch the IC chips on the tops of the ink
cartridges. You may not be able to print
properly.
SC-T7000 Series/SC-T5000 Series/SC-T3000 Series User's Guide
Maintenance
119

Epson SureColor SC-T3000 Specifications

General

Color	Yes
Printing colors	Cyan, Magenta, Matte black, Photo black, Yellow
Print technology	Inkjet
Maximum resolution	2880 x 1440 DPI
Page description languages	HP-GL/2, HP-RTL
Package depth	1125 mm
Package width	787 mm
Package height	825 mm
Package weight	60910 g
Media thickness	0.08 - 1.5 mm
Maximum print size	A1 (594 x 841 mm)
Paper tray media types	Plain paper
ISO A-series sizes (A0...A9)	A1, A2, A3, A4
ISO B-series sizes (B0...B9)	B2, B3, B4
Display	LCD
Country of origin	Japan
Maximum internal memory	256 MB
Sound pressure level (printing)	50 dB
Number of power supply units	1
Power consumption (standby)	0.4 W
Power consumption (typical)	54 W
Power consumption (PowerSave)	3 W
USB connector	USB Type-A
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Quantity per pack	1 pc(s)