Epson TM-L90-i Technical Reference Guide

Chapter 1 Product Overview
43
1
Requirements for Black Mark Position II (when the black mark is between two labels)
• Black mark portions must be printed on the back of paper (non-printing side).
• If label paper meets Black Mark Position Requirement I, it is not necessary to consider Black
Mark Position Requirement II.
•The reflective rates of each portion [1], [2], and [3] must meet the combinations shown in the
table below (the reflective rate is measu
red using the back of the paper, the non-printing side):
Reflective rates are measured by the Macbeth PCM-II (Filter D) meter.
Reflective rate of black mark portion[1]
17%
less
16%
less
15%
less
14%
less
13%
less
Reflective rate of the portion where the
black mark does not exist [2][3]
90%
more
85%
more
80%
more
75%
more
70%
more
Units: mmBack (non-printing side)
Paper feed direction
Preprintable area
15.0 or more
0.5±0.5
[2]
[1]
Cutting position
5.0±0.5
0.5±0.5

Epson TM-L90-i Specifications

General

Type	POS printer
Character size	0.99 x 2.4 mm
Print technology	Thermal
Maximum resolution	180 x 180 DPI
Country of origin	China
Autocutter durability	2 million cuts
Mean time between failures (MTBF)	180000 h
Product color	Gray
Maximum roll diameter	90 mm
USB port	Yes
USB connector	Micro-USB Type-A, Micro-USB Type-B, USB Type-A
USB 2.0 ports quantity	4
Connectivity technology	Wired
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	5 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Wi-Fi	No
Ethernet LAN data rates	10, 100 Mbit/s
Package depth	300 mm
Package width	190 mm
Package height	240 mm
Package weight	3000 g
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	195 mm
Width	145 mm
Height	148 mm