Epson TM-L90-i Technical Reference Guide

Chapter 2 Setup
87
2
Setting for Connected Devices
Follow the steps below to set for devices controlled by the TM-L90-i printer by using EPSON
TMNet WebConfig.
1
Start up a PC for setting.
2
Connect all the printers to be controlled to the network, and turn them
on.
3
Print a status sheet for each printer.
For how to print a status sheet, see "Confirming with a status sheet" on page 78.
4
Start up the web browser on the PC for setting, and enter the TM-L90-i
printer’s IP address in the address bar as shown below.
http://xxx.xxx.xxx.xxx/PrinterConfigurationPage/
EPSON TMNet WebCon fig starts.
5
Select [Configuration], and then [Device].
The [Device Settings] screen appears.
 This printer cannot be deleted from a device.
 The "device ID" for this printer can be changed.
4
5
6
7

Epson TM-L90-i Specifications

General

Type	POS printer
Character size	0.99 x 2.4 mm
Print technology	Thermal
Maximum resolution	180 x 180 DPI
Country of origin	China
Autocutter durability	2 million cuts
Mean time between failures (MTBF)	180000 h
Product color	Gray
Maximum roll diameter	90 mm
USB port	Yes
USB connector	Micro-USB Type-A, Micro-USB Type-B, USB Type-A
USB 2.0 ports quantity	4
Connectivity technology	Wired
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	5 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Wi-Fi	No
Ethernet LAN data rates	10, 100 Mbit/s
Package depth	300 mm
Package width	190 mm
Package height	240 mm
Package weight	3000 g
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	195 mm
Width	145 mm
Height	148 mm