Epson TM-L90-i Technical Reference Guide

Chapter 2 Setup
93
2
• L3 : (L2+1.5) mm
• L4 : (L2*2/5) mm 
If L2 is less than 4mm: (L2 x 1/2)
• L5 : (L1-L2-3) mm
• L6 : 4.7 mm(Fixed)
•If the paper width is 78mm or greater: 70mm
If the paper width is less than 78mm: (paper width - 8)mm
Starting auto setting mode
1
Make sure the power to the printer is off.
2
Open the roll paper cover.
3
Load the roll paper.
For detail, refer to "Installing and Replacing Roll Paper" on page 131
4
Press the FEED button while turning the power on.
5
When the ERROR LED comes on, goes out, and then comes on again,
release the FEED button.
6
Press the FEED button six times.
7
Close the roll paper cover.
The paper is fed automatically, and the new paper layout setting is saved.
Once a setting is completed, the auto setting mode ends and the printer returns to normal
printing status.
Feed button

Epson TM-L90-i Specifications

General

Type	POS printer
Character size	0.99 x 2.4 mm
Print technology	Thermal
Maximum resolution	180 x 180 DPI
Country of origin	China
Autocutter durability	2 million cuts
Mean time between failures (MTBF)	180000 h
Product color	Gray
Maximum roll diameter	90 mm
USB port	Yes
USB connector	Micro-USB Type-A, Micro-USB Type-B, USB Type-A
USB 2.0 ports quantity	4
Connectivity technology	Wired
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	5 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Wi-Fi	No
Ethernet LAN data rates	10, 100 Mbit/s
Package depth	300 mm
Package width	190 mm
Package height	240 mm
Package weight	3000 g
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	195 mm
Width	145 mm
Height	148 mm