Epson TM-T70II-DT

186
Memory Switch Setting Mode
You can configure the memory switches of the printer.
Follow the steps below to run this mode.
1
Close the roll paper cover.
2
Turn on the product while pressing the Feed button. (Keep pressing the
Feed button until the printer starts printing.)
The printer prints current status of the product.
3
After the printing has been completed, press the Feed button for more
than one second.
The printer starts printing instructions.
4
After the printing has been completed, press the Feed button three
times.
5
Then press the Feed button for more than one second.
The printer starts printing instructions for settings. Follow the instructions.
After one setting has been completed, the printer stores the setting and then starts initializing.
After that, the printer returns to the normal mode.
 Receive buffer capacity  BUSY condition
 Processing when data receive error  Auto line feed
 USB power-saving function  Release condition of receive buffer BUSY
 Error signal output  Print density
 Multi-tone print density  Print speed
 Character code table default  Intern
ational character default
 Interface selection  Autocutting after closing cover
 Auto paper reduction  Font auto replacement
 Buzzer control  Communication condition of USB interface
For detailed information about memory switches (customized value), see "Setting the Mem-
ory Switches/Receipt Enhancement" on page 67.