Chapter 2 Setup
69
2
Auto line feed
•Always disabled(initial setting)
•Always enabled
USB power-saving function
Disabled
Enabled (initial setting)
Release condition of receive buffer BUSY
• Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting)
• Releases when the remaining receive buffer capacity becomes 138 bytes
Error signal output
•Enabled (initial setting)
•Disabled
Print density
Selectable from levels 1 to 13 (70% ~ 130%)
Initial setting: level 7 (100%)
Depending on the paper type, it is recommended to set the print density as shown in the table
below for the best print quality.
The USB power-saving function is valid only when the USB interface communication
condition is set to the vendor-defined class and the system configuration is set so that the
USB driver can support the USB power-saving fuction.
This function is enabled only when Receive buffer capacity is set to 4KB.
Original Paper type Density Level
TF50KS-E, P220AGB-1, AF50KS-E Level 5 (90%)
TF60KS-E, PD150R, PD160R, PD190R, KT48F20, KT55F20, F5041 Level 7 (100%)
P300, P310, P350 Level 8 (105%)
When the print density level is increased, printing speed may be reduced.
To Next Page
Loading...
