Epson TM-T83II

133
Appendix
For details about how to set the Software Setting Mode, see "Software Setting Mode" on page 108.
*1: No settings are required.
*2: Do not change the settings.
14: Other Settings 2: Buzzer Control
7: Sound Pattern
(Pulse 2)
Pattern A, Pattern B, Pattern C, Pattern D,
Pattern E
8: Buzzer Fre-
quency(Pulse 2)
1 time
, No sound
9: Buzzer Time
(Autocut)
No Sound
, 1000 ms, 2000 ms, 3000 ms
10: Buzzer Time
(Offline)
No Sound, Continuous, 1000 ms
3: Interface
Settings
1: Receive Buffer
Capacity
4 KB
, 45 bytes
2: BUSY Condi-
tion*
2
Receive Buffer Full or Offline, Receive Buffer
Full
3: Auto Line
Feed*
1
Always disabled, Always enabled
4: State to cancel
buffer BUSY
Not BUSY = 256 bytes
, Not BUSY = 138 bytes
5: Output Paper-
end Signals*
1
Paper End&Near-end Sensor Enabled,
Disabled
6: Error Signal*
1
Enabled, Disabled
4: Near-end
Detection
D
isable, Enable
Setting Item
Setting Values
* Underlined values are the initial settings.
1st page 2nd page 3rd page