Epson TM-T83II

81
Chapter 3 Application Development Information
3
Web Service Settings - Device Admin - Customer Display
You can use this to set communication with the customer display and check its operation.
Item Description
Customer Display Set whether to use the Customer Display.
Communica-
tions settings
Communications
speed (bps)
Set the communication speed.
Usually, not required set.
Data bit Set the data bit length. Usually, not required set.
Parity Set the parity. Usually, not required set.
Brightness settings Set the brightness of the customer display.
You can set 20%, 40%, 60%, or 100%. The maximum bright-ness is
100%.
Test display Performs a test display to the customer display.
Apply Saves settings to TM-T83II-i.