Epson TM-T83II

47
Chapter 2 Setup
2
Paper sensor to output paper-end signals default
•Paper end sensor enabled, paper near-end sensor enabled (initial setting)
•Disabled
Error signal output
•Disabled
•Enabled (initial setting)
Paper near-end sensor
•Disabled (initial setting)
•Enabled
Sounds buzzer on signal output from DK connector pin 2
•Disabled (initial setting)
•Enabled
Sounds buzzer on signal output from DK connector pin 5
•Disabled (initial setting)
•Enabled
Paper width
•80 mm (initial setting)
•58 mm
No settings are required.
No settings are required.
To change the paper width, you need to install the 58-mm width paper guide plate. For
information about how to change the paper width, see "Changing the Paper Width" on page 31.