Epson TM-T83II

57
Chapter 2 Setup
2
Setting for Connected Devices
The ePOS-Device XML, ePOS-Device SDK, and Server Direct Print systems identify controlled
devices by the device ID. The device ID is registered in this product. Set the device ID using EPSON
TMNet WebConfig.
This section briefly explains the setup procedure.
1. Connect the controlled devices
Physically connect (or connect via network) this product to all devices to be controlled by the
product, and turn the power on.
For devices that can be controlled, see "Software Specifications" on page 119.
2. Check the information of the controlled devices
Check the type and IP address of devices to be controlled via this product.
In addition, check the device ID to be set for the controlled devices with the system administrator.
3. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
http://TM-i’s IP address/webconfig/
For detail, see "Starting EPSON TMNet WebConfig" on page 72.
4. Register the controlled devices
From [Printer], [Customer Display], [Key Input Device], or [Serial Communication Device] in the
[Configuration] menu, register and set up the controlled devices.
After setting, click [Apply] or [Add] at the bottom of the screen. Then the settings are written to the
product. If [Apply] or [Add] is not clicked, t
he settings are not applied.
For detail, see the following information.
•Printer: For setting this product and TM printer on the network device IDs and performing test
prints. (page 80)
•Customer Display: For setting whether to use the Customer Display and performing test display.
The communi
cation settings of this product must be made to match the Customer Display's
communication settings.
The device ID is set to fixed, "local_display". (page 81)
•Key In put Device: For setting device IDs for barcode scanners and key input devices, selecting
control scripts, and performing operational tests. (pa
ge 82)
•Serial Communication Device: For setting whether to use the Serial Communication Device, con-
figuring communication settings, and performing communication tests. Communication settings
of this product shou ld match those of a serial communication devi ce. The device ID is set
to fixed,
"local_serial".(page 83)
5. Check the controlled devices
Update the browser and confirm that the devices registered in the Device List are displayed.