48
Print density
Selectable from levels 1 to 13 (70% ~ 130%).
Initial setting: level 7 (100%)
Depending on the paper type, it is recommended to set the print density as shown in the table
below for the best print qu ality.
Print speed
Selectable from levels 1 to 13 (Slow ~ Fast)
Initial setting: level 13
Character code table default
Selectable from 43 pages
Initial setting: Page 0 (PC437: USA, Standard Europe)
International character default
Selectable from 18 sets
Initial setting: USA
Original Paper type Density Level
TF50KS-EY, TF60KS-E, PD160R, PD190R, P220AGB-1, P35024,
AF50KS-E, KT55FA, KT48FA
7 (100%)
F5041 8 (105%)
When the print density level is increased, printing speed may be reduced.
Depending on print conditions, such as print duty, print head temperature, and data
transmission speed, print speed is automatically adjusted, which may cause white lines due to
intermittent print (the motor sometimes stops). To avoid this, keep the print speed constant by
setting it lower, or set the transmission speed higher for the serial interface.
• For the character code table, see "Character Code Tables" on page 134.
• No settings are required.
• For the character code table, see "Character Code Tables" on page 134.
• No settings are required.
To Next Page
Loading...
