Epson TM-T83II Technical Reference Guide

56
Enabling PHP
To use PHP on this product, enable PHP using EPSON TMNet WebConfig.
This section briefly explains the setup procedure.
1. Check the microSD card
Make sure that the microSD card is installed in the microSD card slot on this product.
2. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
http://TM-i’s IP address/webconfig/PHPSetting
3. Enable PHP
Select [Enable] from “PHP”.
After setting, click [Apply] at the bottom of the screen. Then the settings are written to the product. If
[Apply] is not clicked, the settings are not applied.
Setting for Server Direct Print
Set up Server Direct Print using EPSON TMNet WebConfig.
This section briefly explains the setup procedure.
1. Connect this product to a network
Connect this product to a network and turn on the product.
2. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
http://TM-i’s IP address/webconfig/
For detail, see "Starting EPSON TMNet WebConfig" on page 72.
3. Set up Server Direct Print
Select the [Web Service Settings] menu and then [Direct Print], and set Server Direct Print settings.
After setting, click [Apply] at the bottom of the screen. Then the settings are written to the product. If
[Apply] is not clicked, the settings are not applied.
For detail, see "Web Service Settings - Server Access - Direc
t Print" on page 87.

Epson TM-T83II Specifications

General

Brand	Epson
Model	TM-T83II
Category	Printer
Language	English