Epson TM-U295

REVISION SHEET
Sheet 7 of 10
REV. SHEET CHANGED CONTENTS DATE
36
DLE EOT
This command is executed even... ®
With the serial interface model, .... (Change)
38
Table (lower) Bit 6
Off = Slip is not detected.... ® Slip is detected...
On = Slip is detected.... ® Slip is not detected.... (Correction)
42 The way to indicate the command was changed as below.
ESC &
y c1 c2 [x [d] y ´ x] c2 - c1 + 1 ®
ESC &
y c1 c2 [x1 d1...d(y ´ x1)]...[xk d1...d(y ´ xk)] (Change)
44
The way to indicate the command was changed as below.
ESC *
m n
L
n
H
[d]k ®
ESC *
m n
L
n
H
d1...dk (Change)
48
The way to indicate the command was changed as below.
ESC D
[n] k NUL ®
ESC D
n1...nk NUL (Change)
50
ESC L
Change of expression (Change)
54-2 ESC c3 command details (Addition)
ESC {
[Example]
When upside-down mode on ® When upside-down mode off
When upside-down mode off ® When upside-down mode on
(Correction)
D
63
(Correction)
TITLE
TM-U295/U295P
Specification
(STANDARD)
®