Epson vs 230 - Selecting Projector Network Settings; Setting up a Projector to Connect in Advanced Connection Mode (Wired)

11
Configuration File feature on the Environment setup screen. Then copy the resulting configuration file
to the following directory on the other computer.
C:\ProgramData\SEIKO EPSON CORPORATION\Epson Projector Management
Parent topic: Installing the Software
Related references
Environment Setup - General
Selecting Projector Network Settings
Follow these instructions to select a connection method between a computer and the projector, and then
set up the projector.
Connect the projector to your network using the Advanced connection mode.
To update the projector firmware or copy the projector settings, connect the projector using a wired
network system.
Setting Up a Projector to Connect in Advanced Connection Mode (Wired)
Setting Up a Projector to Connect in Advanced Connection Mode (Wireless)
Parent topic: Setting Up the Software for the First Time
Setting Up a Projector to Connect in Advanced Connection Mode (Wired)
To connect a computer to the projector using a wired LAN, you need to select network settings on the
computer and the projector.
1. Connect the computer to the network.
Note: To set up a network connection, if necessary, see the documentation supplied with your
computer or network adapter.
2. Connect a LAN cable to the projector.
3. Turn on the projector.
4. Press the Menu button on the remote control or the control panel, and select the Network menu.
5. Select these IP settings for your wired LAN as necessary.
• DHCP is available: Set DHCP to On.
• DHCP is not available: Set DHCP to Off and enter the projector's IP Address, Subnet Mask, and
Gateway Address values as necessary.
Downloaded from ManualsNet.com search engine