Epson vs 230 - Copying Projector Menu Settings in a Batch

33
• Set the date and time you want to perform the firmware update, and then click Schedule to
schedule the update.
The update schedule is displayed on the right pane of the Update List view.
Note:
• To change the update schedule, select the schedule on the right pane and click Edit.
• To delete the update schedule, select the schedule on the right pane and click Delete.
• You can view up to 500 schedules on the right pane of the Update List view. When the number of
schedules exceeds 500, schedules are deleted as necessary beginning with the oldest schedule.
• To delete all completed schedules, right-click at any point on the right pane and select Delete Old
Schedules.
The firmware is updated at the date and time you set, and the LED indicator on the projector turns on.
When the firmware update is complete, the projector turns off and it enters standby mode. While
updating, you can check the firmware update status on the right pane of the Update List view.
Note:
• Do not close the Epson Projector Management software while updating the firmware.
• If you try to close the Epson Projector Management software when there is a scheduled update
standing by, a confirmation message is displayed. Scheduled updates are executed only while the
Epson Projector Management software is running.
• You may need to reconfigure the projector's network settings after updating the firmware since the
network settings may be changed by the firmware update process.
Parent topic: Updating the Firmware
Copying Projector Menu Settings in a Batch
You can copy the menu settings from one projector to one or more other projectors that are the same
model and have the same firmware version. This allows you to quickly duplicate projector menu settings
in a batch setup operation.
You can copy menu settings in a batch setup operation right away or schedule a time to copy them.
When you copy the menu settings, make sure of the following:
• The projector is connected using a wired network system.
• The projector is turned on or the projector's Standby Mode is set to Communication On.
Downloaded from ManualsNet.com search engine