Epson vs 230 - Solutions When You Cannot Find Connected Projectors (Wireless)

56
Parent topic: Solving Network Connection Problems
Related tasks
Setting Up a Projector to Connect in Advanced Connection Mode (Wired)
Solutions When You Cannot Find Connected Projectors (Wireless)
When you cannot find the projector over a network using a wireless connection, try the following
solutions. If you cannot resolve the problem, contact your network administrator.
• Check the status of the external devices used for the network connection or the environment in which
the network devices and the projector are located.
• Connect the specified wireless LAN unit to the projector securely, if necessary. See your projector
User's Guide for details.
• Check for any obstacles between the access point and the computer or projector, and change their
position to improve communication. Sometimes, indoor environments prevent the projector from
being found in a search.
• Make sure that the access point and the computer or projector are not too far apart. Move them
closer together and try to connect again.
• Check for interference from other equipment, such as a Bluetooth device or microwave. Move the
interfering device farther away or expand your wireless bandwidth.
• Set the radio strength for the network devices to the maximum.
• Set the IP address, the subnet mask, and the gateway address for the access point correctly.
• Make sure the wireless LAN system of the access point supports the projector's wireless LAN
system.
• Check the projector's network settings.
• Set the Connection Mode setting to Advanced.
• Set the computer, the access point, and the projector to the same SSID.
• Set DHCP to Off. When DHCP is set to On, it may take some time to enter LAN standby status if an
available DHCP server is not found.
• Set the IP address, the subnet mask, and the gateway address for the projector correctly.
• Turn on the wireless LAN setting, if necessary.
• Set the wireless LAN system to meet the standards supported by the access point.
• When you enable the security setting, set the same passphrase for the access point, the computer,
and the projector.
Downloaded from ManualsNet.com search engine