14
Registering the Projectors
Follow the instructions here to register your projectors for management on a network.
Registering Projectors for Monitoring
Registering Projectors for Monitoring
To manage projectors, you must register the projectors to the Epson Projector Management software.
Once registered, the projector status is automatically displayed when you start the Epson Projector
Management software.
If you need to register a large number of projectors, you can create projector groups so you can monitor
and control the projectors in small units.
You can register up to 2000 projectors and groups in total. To monitor a large number of projectors,
make sure your computer meets or exceeds the system requirements.
Searching for Projectors
Creating a Projector Group
Parent topic: Registering the Projectors
Related references
System Requirements
Searching for Projectors
You can search for projectors on the same segment automatically or search for projectors by specifying
an IP address.
1. Start the Epson Projector Management software.
• Windows 8.1: Navigate to the Apps screen and select Epson Projector Management Ver.X.XX.
• Windows 10: Select Start, select EPSON Projector, and then select Epson Projector
Management Ver.X.XX.
The Epson Projector Management software starts.
2. Select Projector from the menu bar and select Projector Registration.
The Projector Registration screen appears.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
