Error Messages Solution
Paper jam. Press to see how to remove jammed paper.
R & 132
Paper out or paper jam. Check paper size and load paper
in paper cassette.
Load some paper or clear the jammed paper. Otherwise, make sure the
number of sheets does not exceed the limit specied for the type of
media you are using. R & 24, 132
Paper jam inside, in back, or in ADF. Press
to see how to
remove jammed paper.
R & 135, 136
Paper feed error or jam. Remove the paper and reload
paper correctly. See your documentation.
R & 137
Communication error. Make sure the computer is
connected, then try again.
Make sure the computer is connected correctly. If the error message
still appears, make sure that scanning software is installed on your
computer and that the software settings are correct.
Printer error. Turn power o and then on again. For details,
see your documentation.
Turn the printer o and then back on. Make sure that no paper is still in
the printer. If the error message still appears, contact Epson support.
A printer’s ink pad is nearing the end of its service life.
Please contact Epson Support.
Press x to resume printing. The message will be displayed until the ink
pad is replaced. Contact Epson support to replace ink pads before the
end of their service life. When the ink pads are saturated, the printer
stops and Epson support is required to continue printing.
A printer’s ink pad is at the end of its service life. Please
contact Epson Support.
Contact Epson support to replace the ink pad.
Backup Error.
Error Code xxxxxxxx
A problem occurred and backup was canceled. Make a note of the
error code and contact Epson support.
No dial tone detected. Try Check Fax Connection. Make sure the phone cable is connected correctly and the phone line
works. R & 66 If you connected the product to a PBX (Private Branch
Exchange) phone line or Terminal Adapter, turn o the Dial Tone
Detection. R & 94
The combination of IP address and subnet mask is invalid.
See your documentation.
Refer the online Network Guide.
Recovery Mode The rmware update has failed. You will need to re-attempt the
rmware update. Ready a USB cable and visit your local Epson website
for further instructions.
Error Messages
Messaggi di errore
Mensajes de error
Mensagens de erro
EN
EN
R & 124
If the displayed error message indicates that the size of the loaded paper does not match the paper size setting, load the correct paper
and set the paper size again. R & 26
IT
ES
PT
R & 127
R & 126
R & 125
To Next Page
Loading...
Need help?
General
