Epson WF-C20590 Installation Guide

WF-C20590 Installation Guide
Installing the Optional Units 31
Installing the Optional Units
Installing the Bridge Unit
 Minimum workers
 1 person
 Items needed
 Phillips screwdriver
 Flathead screwdriver
 Wrench (included in the Bridge Unit box)
 Joint parts (included in the Bridge Unit box)
INSTALLATION SPACE
You will need to adjust the height of the Bridge Unit with the casters on the
bottom of the unit. Allow at least 19.7 inches (500 mm) between the rear of the
printer and the wall where the unit will be installed.
Be sure to check the following notes before the installation:
 All workers must read the installation procedure together
before starting work.
 Wear easy-to-move clothing, gloves, and safety shoes.
 Work with care to avoid injuries.
 Work with sufficient working space.
 Use proper lifting techniques, and stop working
immediately if you feel that the load is too bulky or heavy.
C H E C K
P O I N T
After connecting the Bridge Unit to the printer, you can store the
parts below inside the Finisher Unit.
EJ Stacker
EJ Cover, Lower
19.7 in (500 mm)
PRELIMINARY

Epson WF-C20590 Specifications

General

Connectivity	USB, Ethernet, Wi-Fi, Wi-Fi Direct
ADF Capacity	150 sheets
Monthly Duty Cycle	Up to 400, 000 pages
Category	All in One Printer
Functions	Print, Copy, Scan, Fax
Duplex Printing	Yes
Print Technology	PrecisionCore
Print Speed	Up to 100 ppm (black/color)
Print Resolution	600 x 2400 dpi
Scanner Type	Color flatbed/ADF
Scan Resolution	600 dpi
Ink Cartridges	Black, Cyan, Magenta, Yellow
Display	9-inch touchscreen