1 TEST PROGRAMS AND ADJUSTMENTS44 / 266
Test program no. 12
Setting the FORCED voltage
Characteristics of version vs nr 2
The characteristics are between those of the vs nr 1 and those of the vs nr 3.
FORCED voltage version vs nr 3
A power limitation of 1 to 30 watts increases the no-load voltage constantly up to approx. 2,300 V
p
. Above
30 watts power limitation, the no-load voltage is limited to approx. 2,300 V
p
.
Characteristics of version vs nr 3
• Image interferences on monitors possible.
• Danger of burns from contact with a terminal possible.
• Heavy spark formation with coagulation via a terminal.
• Heavy spark formation also at a 30 watts power setting.
To direct high-frequency power into the tissue, the tissue must not necessarily be contacted (current flow or
powered transmission [see vs nr 2] possible via arc).
FORCED voltage version vs nr 4
A power limitation of 1 to 30 watts increases the no-load voltage constantly up to approx. 2,600 V
p
. Above
30 watts power limitation, the no-load voltage is limited to approx. 2,600 V
p
.
Characteristics of version vs nr 4
• Image interference on monitors possible.
• Danger of burns from contact with a terminal possible.
• Heavy spark formation with coagulation via a terminal.
• Heavy spark formation also at a 30 watts power setting.
To direct high-frequency power into the tissue, the tissue must not necessarily be contacted (current flow or
powered transmission [see vs nr 2] possible via arc).
Important notes
• The vs no set only applies to FORCED AUTO COAG 1, FORCED AUTO COAG 2 and for programs
0 to 11.
• For the MIC program, vs nr 1 is automatically set.
• In case of memory failure, vs nr 1 is automatically set.
When switching on the power supply, vs nr 2, vs nr 3 or vs nr 4 (V4.0) is briefly displayed. The standard vs
nr 1 is not displayed.
To Next Page
Loading...
