Ercolina TB100 - Page 3

– 3 –
_____________________________________________________
CML USA Ercolina
®
reserves the right to make improvements and
modications to design without prior notice.
_____________________________________________________
Automatic bending
• Automatic mode - without pressure die control 39-40
Automatic menu selection
(determining and entering proper springback value for bend angles) 41-45
• Automatic mode - with pressure die control 46-48
Automatic menu selection
(determining and entering proper springback value for bend angles) 49-53
MDA mode
• Manual selection of bend angle within a program 54
Services
• Selecting unit of measure 55
• Alarm list display and overview 56-57
• Changing language 58
• Accessing protected area 59
Diagnostics and Accessories:
• Referencing "C axis" position 60-61
• Grounding and wiring schematics 62-73
• Electrical parts list 74-76
• Gear case schematic 77-78
• Material length required for rotary bends in pipe (tube and pipe information) 79
• Conversion tables - mm to inches and inches to mm 80
• Minimum distance between bends by center line radius, pipe and tube kits 81
• Tooling for pipe 82
• Tooling for tube 83-84
• Non-mandrel bending troubleshooting 85
• Routine maintenance & grease information 86
• Terms and conditions of sale 87
• Warranty 88
• Ercolina tube, pipe, profile benders and angle rolls 89-90
TB100/TB13003/2015