– 40 –
Parameters:
● PROG: Program number.
Displays program number value from 0 to 1999.
● COM: Comment text associated to the program number (max 24 characters)
● BEND: Current bend number (or line number) you can edit this value to choose the
initial line number to start cycle.
● PROG: Program value for c axis.
● SB: Springback correction for C axis.
● ACT: Current position for C axis.
● DTG: Distance to go for C axis.
Hand-held control display
In Automatic mode the machine will perform only the program displayed on the screen. To change
programs, refer to page 38 of this manual.
03/2015TB100/TB130
To Next Page
Loading...