Ericsson iPECS LIP-8002E - Page 255

LIP-8040E Gigabit Phone User Guide
47
5.5 Call Park: Placing a call on Hold to Page
A user may transfer an active CO/IP call to a special
holding location (Park Orbit), which can be accessed
easily from any station in the system. Typically, this
feature is used with Paging to notify the desired user of
a parked call.
Parked calls are subject to Hold Recall after the Call
Park timer.
In iPECS-LIK, iPECS SBG-1000
To park an active external call:
• Press TRANS/PGM,
• Dial the Park Orbit (601-610 for iPECS SBG-1000 & 50 & 100,
or 601-619 for iPECS-300 & 600 or 601-800 for iPECS-1200),
• Return to idle.
To retrieve a parked call:
• Lift the handset,
• Dial the Park Orbit.
In iPECS-MG
To set-up a Conference Room:
• Press the TRANS/PGM button,
• Dial 54 to create a Conference Room,
• Dial the desired Conference Room number (571-579),
• If desired enter a password for the Conference Room (up to 12
digits),
• Press HOLD/SAVE to establish the Room.
To join a Conference Room:
• Lift the handset,
• Dial 571-579 (Conference Room entry code),
• Dial the Conference Room password.
To delete a Conference Room:
• Press the TRANS/PGM button,
• Dial 55 (Conference Room delete code),
• Dial the Conference Room number (571-579),
• Dial the Conference Room password,
• Press HOLD/SAVE to delete the Conference Room.