LIP-8008E User Guide
27
2000-4999). The iPECS-600 system has memory
allocated for 6000 System Speed Dial numbers (bins
2000-7999). The iPECS-1200 system has memory
allocated for 12000 System Speed Dial numbers (bins
20000-31999). The iPECS-MG100 system has memory
allocated for 1000 System Speed Dial numbers (bins
2000-2999). The iPECS-MG300 system has memory
allocated for 2000 System Speed Dial numbers (bins
2000-3999).
You may, if allowed, use System Speed Dial to call
frequently dialed numbers.
In some cases, these numbers are divided into groups
called System Speed Zone Groups. In this case, you
may access some numbers and not others and your
dialing restrictions may be invoked.
Only an Attendant can assign System Speed Dial
numbers.
3.3.4 Using and Entering Station Speed Dial Numbers
Each station in the iPECS SBG-1000 & 50 & 100
System is allocated memory for 20 Station Speed Dial
numbers (bins 00-19) each up to 23 digits. The iPECS-
300 & 600 & 1200 each support 100 Station Speed
Dial numbers (bins 000-099). The iPECS-MG 100 &
300 each support 50 Station Speed Dial numbers (bins
000-049). These numbers are entered at the user’s
station and may include several ‘special’ instructions.
Special instructions and the corresponding button are:
PAUSE will momentarily stop dialing.
FLASH as 1
st
digit—Activate dial tone detect.
FLASH not as 1
st
digit—The system will generate a
flash on the CO line.
CALL BACK as 1
st
digit—Send digits as ISDN
Keypad Facility message.
‘*’ as 1
st
digit—Display Security, the stored
number will not be displayed when used.
To place a call using System Speed Dial:
• Lift the handset,
• Press SPEED,
• Dial the desired System Speed Dial bin number (200-999 for
iPECS SBG-1000 & 50 & 100, 2000-4999 for iPECS-300,
2000-7999 for iPECS-600, 20000-31999 for iPECS-12000,
2000-2999 for iPECs-MG100 , or 2000-3999 for iPECS-
To Next Page
Loading...
