ESAB ESP-101 - Page 8

8
5. AWS C5.5 - "Recommended Practices for Gas Tung-
sten Arc Welding“
6. AWS C5.6 - "Recommended Practices for Gas Metal
Arc Welding"“
7. AWS SP - "Safe Practices" - Reprint, Welding Hand-
book.
8. ANSI/AWS F4.1, "Recommended Safe Practices for
Welding and Cutting of Containers That Have Held
Hazardous Substances."
Means immediate hazards which,
if not avoided, will result in im-
mediate, serious personal injury
or loss of life.
Means potential hazards which
could result in personal injury or
loss of life.
Means hazards which could result
in minor personal injury.
SECTION 1 SAFETY PRECAUTIONS
MEANING OF SYMBOLS - As used
throughout this manual: Means Atten-
tion! Be Alert! Your safety is involved.
The IP code indicates the enclosure class, i.e. the degree of protection against penetration by solid objects or
water. Protection is provided against touch with a nger, penetration of solid objects greater than 12mm and
against spraying water up to 60 degrees from vertical. Equipment marked IP23S may be stored, but is not in-
tended to be used outside during precipitation unless sheltered.
Enclosure Class
This product is solely intended for plasma cutting. Any other use may re-
sult in personal injury and / or equipment damage.
15°
Maximum
Tilt Allowed
If equipment is placed on a surface that
slopes more than 15°, toppling over may oc-
cur. Personal injury and / or signicant dam-
age to equipment is possible.
To avoid personal injury and/or equipment
damage, lift using method and attachment
points shown here.
CAUTION
CAUTION
CAUTION