Fire Alarm-Computer 8000C Pag
e 155
Fig. 10: Selection of the detector status for simulation
♦
Enter the zone and detector number of the fire detector or TAL module.
♦
Press the
Select
function key.
♦
Enter the number for the desired function ( 1 = Alarm, 2 = Pre-alarm, 3 =Trouble, 4 = End test)
or select with the cursor keys and press the Function
function
key to acknowledge the input.
To end this simulation
Each individual detector (or zone) whose operating state has been simulated must be terminated
with the End test function !
Commissioning / Servicing
Status Function
1 Alarm
2 Pre-alarm
3 Trouble
4 End test
Detector simulation
Detector
: 20
: 12
Zone
To Next Page
Loading...