Fire Alarm Computer 8000C
Page 39
4.9 Lamp test
The Lamp test function is activated for approx. 10 seconds to check the optical displays.
Press Key
Test
Fig. 41: Lamp test start
♦
All optical displays (LED) of the operating panel and the single zone indicator unit (if installed)
illuminate.
♦
The display area of the plaintext display is completely darkened.
♦
The control panel buzzer sounds.
♦
The versions No. of the employed software is then shown on the display.
This function ends automatically after approx. 10 seconds!
Renewed depression of the
Test
key interrupts the lamp test before the expiry of 10 seconds!
Lamp test
To Next Page
Loading...