Page 42
Fire Alarm Computer 8000C
Switch on / disconnect Primary loops:
♦
Enter the number of the primary loop which is to be switched on and press the
Select
function
key
♦
Enter the number of the desired function (1 = switch on/reset, 2 = switch off) or select the menu
point with the cursor keys and press the
Function
key
In the case of an input error, the display can be erased by pressing the
Zone
key and the primary
loop number can be re-entered.
!
When a primary loop, for example a 4-zone module or an analog ring loop module is
disconnected, all detector zones and fire detectors connected to this module are
disconnected. Disconnected fire detectors will not activate an alarm in the case of an
event.
Service Level
To Next Page
Loading...