Evalue Technology ECM-3610 - BIOS Boot Configuration; Quick POST and Boot Device Selection

ECM-3610/3610L
ECM-3610/3610L User’s Manual 55
4.5.3.4 CPU L2 Cache ECC Checking
This item allows you to enable/disable CPU L2 Cache ECC checking.
Enabled Enable L2 Cache ECC Checking
Disabled Disable L2 Cache ECC Checking
4.5.3.5 Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power up the computer. If
it is set to Enable, BIOS will shorten or skip some check items during POST.
Enabled Enable quick POST
Disabled Normal POST
4.5.3.6 First/Second/Third/Other Boot Device
The BIOS attempts to load the operating system from the devices in the sequence
selected in these items.
Floppy Floppy Device
LS120 LS120 Device
HDD-0 First Hard Disk Device
SCSI SCSI Device
CDROM CDROM Device
HDD-1 Secondary Hard Disk Device
HDD-2 Third Hard Disk Device
HDD-3 Fourth Hard Disk Device
ZIP100 ZIP-100 Device
USB-FDD USB Floppy Device
USB-ZIP USB ZIP Device
USB-CDROM USB CDROM Device
USB-HDD USB Hard Disk Device
LAN Network Device
Disabled Disabled any boot device
4.5.3.7 Boot Up Floppy Seek
Seeks disk drives during boot up. Disabling speeds boot up.
Enabled Enable Floppy Seek
Disabled Disable Floppy Seek
4.5.3.8 Boot Up NumLock Status
Select power on state for NumLock.
Enabled Enable NumLock
Disabled Disable NumLock