Evalue Technology ECM-3610 - Chipset Graphics and USB Settings; AGP Aperture Size and Mode Settings; AGP Driving Control, Panel Type, Boot Device, and USB; USB Keyboard Support Configuration

User’s Manual
60 ECM-3610/3610L User’s Manual
4.5.4.10 AGP Aperture Size
Select the size of Accelerated Graphics Port (AGP) aperture. The aperture is a portion of
the PCI memory address range dedicated for graphics memory address space. Host
cycles that hit the aperture range are forwarded to the AGP without any translation.
The Choice: 4M, 8M, 16M, 32M, 64M, 128M
4.5.4.11 AGP-4X Mode
This item allows you to enable / disable the AGP-4X Mode.
The Choice: Enabled, Disabled.
4.5.4.12 AGP Driving Control
This item allows you to select the AGP Driving Control to auto / disable Mode.
The Choice: Auto, Disabled.
4.5.4.13 AGP Driving Value
This item allows you to set the AGP Driving value.
The Choice: 00 ~ FF (Hex)
4.5.4.14 Panel Type
This item allows you to switch panel type.
The Choice: 00 ~ 0F .
4.5.4.15 Boot Device Select
This item allows you to switch the system boot up display mode.
The Choice: Auto, Both.
4.5.4.16 OnChip USB
This should be enabled if your system has a USB installed on the system board and you
wish to use it. Even when so equipped, if you add a higher performance controller, you
will need to disable this feature.
The choice: Enabled, Disabled.
4.5.4.17 USB Keyboard Support
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you
have a USB keyboard that want to using in DOS mode.
The choice: Enabled, Disabled.