29
Eversense E3 CGM User Guide
3
8. On the PAIR YOUR
TRANSMITTER screen,
the smart transmitter ID
detected by the app is listed
as “Not Connected”. (Your
smart transmitter ID matches
the serial number found on the
back of the smart transmitter.)
• Tap Not Connected to
begin pairing process.
9. A BLUETOOTH
PAIRING REQUEST
pop-up screen appears.
• Tap Pair to complete the
pairing process.
Note: The smart transmitter
can only be paired with one
mobile device at a time.
7. With the smart transmitter
turned on, and when the PAIR
YOUR TRANSMITTER
screen appears on your
mobile device, set your smart
transmitter to “Discoverable”
mode for the mobile device
to find the smart transmitter:
• Press the smart transmitter
power button three times.
Make sure your smart
transmitter is not plugged
into the power supply.
• The LED will flash green
and orange to indicate
the smart transmitter is
in Discoverable mode.
Power button
Note: If you press the power
button on the smart transmitter
and no LED appears, press
and hold the power button for
about 5 seconds to turn it on.
To Next Page
Loading...
