CAUTION:
Pay attention to the following when transporting the product to a high place or using
it at height
l
Inspect the product in advance
l
Take fall prevention measures
l
Give due consideration to safety
When used in a high temperature atmosphere, pay close attention to the temperature
of the tip and inserting part as they will not cool down immediately after use
They may cause burns.
Be careful not to get your feet caught on the cords such as the inserting part and
cables
If you feel any abnormality during insertion, do not try to insert the device forcibly
any further and gently pull out the inserting part
Note the following when pulling out the inserting part
l
Do not pull it out from the inspection object while the inserting part is curved
l
If the inserting part is caught during withdrawal, pull it out while turning the part
gently
Pay attention to the following points when handling the tip of the inserting part
l
Do not drop or make an impact on the tip
l
Do not hit the tip on other objects or pull the tip
l
Do not move around while holding the tip
l
Do not squash or fold the curved part
Since it is composed of glass lenses and precision parts, it may be damaged.
If you feel any abnormality during bending operation, do not try to bend the product
forcibly
Otherwise, the inserting part or inspection object may be damaged.
Do not insert metal or other foreign objects into the product through gaps such as
connector terminals
Otherwise, it may be damaged and an electric shock may occur.
Do not use underwater, wash under running water, or splash water on parts other
than the inserting part
An electric shock may occur. Do not use or store the product under water.
Wear safety glasses when directing air from the air connection part of the protection
sleeve
If you connect an air tube or pump to the air connection part of the protection sleeve and
send air, there is a risk that liquid or dust will spatter. Wear safety glasses to avoid eye injury.
4
To Next Page
Loading...