IPLEX TXII
NOTE:
Do not store the product in the following locations
l
High temperature, high humidity, dusty environments
l
Locations exposed to direct sunlight or radiation
l
Locations exposed to gases containing halides
*1
The product may break down.
*1 The performance of certain electrical components may be degraded by the effects
of halides contained in insecticides, herbicides, gas fire extinguishers, etc.
Do not continue to use the product with dew condensation
Condensation may form inside the unit when there is a sudden change in temperature, for
example, when the product is moved from the cold outdoors into a warm room. If dew
condensation occurs, turn off the power, allow the product to adjust to the temperature of
the operating environment, and use it after the dew condensation disappears as using the
product with dew condensation may cause it to malfunction.
Do not insert the inserting part into the inspection object in an environment with a
temperature exceeding the operating temperature range
If you continue to use the product, it may cause a malfunction or performance deterioration.
Do not use the product with contaminants on its outer surface
Otherwise, it may cause malfunction or performance degradation.
Do not cover the product with plastic bags, etc.
The inside may not be cooled sufficiently, which may cause damage.
Do not allow liquids other than water, salt water, machine oil, and light oil to adhere
to the inserting part
The inserting part may be damaged.
Pay attention to the following when handling each terminal of this product
l
Do not touch the terminals directly
l
Do not allow dirt or water droplets to adhere to the terminals
Be careful not to allow splashed water droplets to come into contact with the
terminals
Be careful not to allow water droplets to come into contact with the terminals of the control
unit and scope unit. The product may break down.
Pay attention to the following when removing the product from the carrying case
l
Do not pull up the product by holding the inserting part
The product may be damaged.
Do not strongly pull on the inserting part or other cables, or move around while
holding them
5
To Next Page
Loading...