Model Topic
Where to Find (Book Year /Section)
Other References
115 – 200 Oil to fuel hose eliminated 2008 - Oiling System
115 – 200 60° models - Water separating fuel filter kit 2008 - Parts & Accessories
115 – 200 60° models - revised oil hose routing 2008 - Powerhead
115 – 200 60° models - Upper mount screw change and service tip 2008 - Powerhead
115 – 200
60° models - Powerhead replacement kits have revised oil
hose routing
2009 - Powerhead
115 – 200 60° models - New flywheel cover 2009 - Rigging
115 – 200
60° models - Ignition coil mounting bracket, mounting
location changed
2009 - Ignition & Electrical
115 – 200 60° models - Starter cable service kit, improves starting 2009 - Ignition & Electrical
115 – 200
60° models - water separating fuel filter added to 2009
models
2009 - Fuel System
115 – 200
60° models - vapor separator, P/N 5006084, pressure test
port changed
2009 - Fuel System
115 – 200 60° models - Rear oil manifold bracket 2009 - Oiling Systems
115 – 200 60° models - Improved shift lever, eliminates lost motion 2009 - Gearcase
115 – 200 60° models only - Oil filter installation
2008 - Rigging
2009 - Rigging
115 – 200 60° models only - Flywheel Stud 2010 - Product Improvements
115 – 250 60° V4 and 60° V6/90° V6 starter motors are different 2008 - Ignition & Electrical
115 – 250
60° V4 and 60° V6/90° V6 starter motors differences and
changes
2009 - Ignition & Electrical
115 – 250 Exhaust relief muffler not serviceable 2008 - Midsection
115 – 250 Oil switch improvement 2008 - Oiling System
115 – 250 Auxiliary battery charge kit 2008 - Parts & Accessories
115 – 250 Trim switch extension kit 2008 - Parts & Accessories
115 – 250 Exhaust back pressure sensor damage 2008 - Powerhead
115 – 250 Code 38 issue 2008 - Rigging
115 – 300
2008 and newer - Service fuel injector electrical
connectors
2009 - Fuel System
115 – 300
Code 77; Start assist circuit over current detected - false
setting
2009 - Service Codes
To Next Page