Evinrude E-tec 2011 Series - Page 91

89
APPENDIX
Model Topic
Where to Find (Book Year /Section)
Other References
115 – 300 New engine wiring harnesses 2009 - Ignition & Electrical
115 H.O. – 130 New water pump kit, P/N 5007556 2009 - Cooling Systems
115 H.O. – 130 New impeller housing, P/N 5007554 2009 - Cooling Systems
115 H.O. – 130 V4 Exhaust adapter improvements 2009 - Midsection
115 H.O. – 300
EMM changes 2009 - Engine Management Module
115 H.O. – 300 Inductive ignition new on these models 2009 - Ignition & Electrical
150 – 200
60° models only - Air silencer change can improve
performance
2008 - Fuel System
150 – 200 60° models - Powerhead alignment 2009 - Powerhead
150 – 200
60° models - New inner exhaust housing, P/N 354148,
improved water flow
2009 - Midsection
150 – 250 M2-Type Gearcase - information 2008 - Gearcase
150 – 250 L2-Type Gearcase - information 2008 - Gearcase
150 – 250 Forward gear and bearing changes 2008 - Gearcase
150 – 250 Propeller shaft bearing housing retainer tabs 2008 - Gearcase
150 – 250 White "Stars and Stripes" decal kits 2008 - Parts & Accessories
150 – 250 "Stars and Stripes" decal kits 2009 - Parts & Accessories
150 – 300 How to identify L2-type gearcase 2009 - Gearcase
150 – 300 Powerhead installation, apply Permatex #2 to gasket area 2009 - Powerhead
200 – 250 90° models - New trim and tilt assembly 2008 - Midsection
200 – 250 Engine idle temperature 2008 - Cooling System
200 – 250 Thermostat venting 2008 - Cooling System
Service Bulletin
2005-03(S)
200 – 250 Melted propeller hub, modifications to help prevent 2008 - Cooling System
Service Bulletin
2005-04(S)
200 – 250 Fuel inlet hose clip 2008 - Engine Covers
Warranty Bulletin
2005-01(W)
200 – 250
DI models only - Alternate spark plug for extended low
speed operation
2008 - Ignition & Electrical