Evinrude E-tec 2011 Series - Page 92

90
Model Topic
Where to Find (Book Year /Section)
Other References
200 – 250
Service Bulletin
2005-05(S)
200 – 250
Service Bulletin
2006-02(S)
200 – 250 Oil to fuel hose eliminated 2008 - Oiling System
200 – 250
90° models - Oil recirculation changes 2004-2006 to 2007
& newer
2008 - Oiling System
200 – 250 90° models - Flushing adapter 2008 - Parts & Accessories
200 – 250 90° models - Powerhead replacement kits
2008 - Powerhead
2009 - Powerhead
200 – 250 2005 models - Oil priming issue 2008 - Rigging
Service Bulletin
2004-02(D)
200 – 250 90° models - Adapter kit, P/N 5007589 2009 - Midsection
200 – 250 90° (3.3 L) models - Adapter, P/N 5001496 2009 - Midsection
200 – 250 Issue with flushing adapter, P/N 775385 2009 - Cooling System
200 – 250 Knock sensors added to these models 2010 - Product Improvements
200 – 250 3.3 L Models - Water plate, P/N 347251 2010 - Service Tips
200 – 300 90° models - Ignition coil mounting location, coil damage 2009 - Ignition & Electrical
200 – 300 90° models - Pinched oil lines 2009 - Oiling Systems
200 – 300 90° models - Powerhead to adapter gaskets different 2009 - Midsection
200 – 300 90° models - Trim and tilt assembly improvements 2009 - Midsection
200 – 300 90° models - New pinion bearing, P/N 5007751 2009 - Gearcase
200 – 300 90° models - Trim Limit Rod, P/N 354185 2010 - Product Improvements
250 H.O. Important engine management software update 2009 - Engine Management Software
Warranty Bulletin
2008-04 (W)
250 H.O. Water pump installation 2009 - Cooling Systems
Warranty Bulletin
2008-04(W)
250 H.O. – 300 Important engine management software update 2009 - Engine Management Software
Warranty Bulletin
2008-06 (W)
250 H.O. – 300 Codes 1 through 6: Excessive knock detected 2009 - Service Codes
Spark plug life 2008 - Ignition & Electrical